Universal Remote Control MRF-260 Manual de instalación descargar pdf (Pagina 5)

Page 2

MRF-260i BASE STATION

Features and Benefits

Interference Rejection and Extended Range via Narrow Band

The MRF-260i receives RF (radio frequency) signals via its integrated

RF receiver and antenna. The MRF-260i displays RF interference via a

bright red Status LED, which flickers when interference is present if the

ID is set to 0. Simply relocate the MRF-260i should interference occur.

Two Fixed IR Outputs

The MRF-260i is equipped with two fixed IR line outputs with standard

3.5 jacks for standard IR emitter/flashers.

Two Variable IR Outputs Match Rear Panel IR Inputs

The MRF-260i is equipped with two adjustable IR line outputs. Each

output can be individually matched to rear panel IR inputs on any

component that is designed to be operated by a standard IR repeater.

The outputs utilize a 3.5mm jack and are compatible with standard IR

emitter/flashers as well.

Up To Fifteen Equipment Locations With Identical Components

Each MX/TX remote is “addressable.” They can be programmed to

specifically control components in a particular room by installing an

MRF-260i base station at each location

. In operation it’s simple: when

you select a device located in the Den, the MX/TX remote only sends

commands to the Den. When you select a device located in the

Family Room, the MX/TX remote only sends commands to it.

A Single MRF-260i Can Control an Array of Identical Components

or Identical Zones of a Multi Zone Preamp/Matrix Switcher

Each MRF-260i has four “addressable” IR Line Outputs. For example,

you can control up to four identical TV’s with one MRF-260i or route

volume commands for a specific zone to a particular zone IR input on

a multi-zone preamp. If you have more than four identical compo-

nents or zones, up to 15 additional MRF-260is can be installed to con-

trol them (thus allowing up to 60 identical components or zones in

one house).

Parts Guide

The MRF-260i RF Base Station includes:

1 - MRF-260i Base Station

1 - Mounting Plate for wall mounting

the MRF-260i

4 - Screws for wall mounting

4 - Visible Flashers with 10 foot plug in

cables.

4 - Extra self adhesive pads for

Emitters

12 - Labels for IR Line Outputs

1 - Screwdriver for Variable Outputs

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comentarios a estos manuales

Sin comentarios

Universal Remote Control MRF-260 Manual de instalación Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Universal Remote Control MRF-260