Universal Remote Control Thermo Control Manual de instrucciones descargar pdf (Pagina 40)

™

QUICK PROGRAMMING GUIDE FOR TILT WIREFREE RTS MOTOR

BEFORE YOU BEGIN

The following steps must be completed to ensure proper blind

programming and functionality. Power should ONLY be connected

Connect 12V battery wand or transformer to the

motor. Motor should already be installed in blind.

This step cannot be performed if the transmitter has already been

programmed (memorized) to blind.

On the transmitter, press and hold both the UP and DOWN simultaneously

until the blind jogs (blind slats have a short up and down tilt movement).

Using the channel selector, select the desired channel. On the transmitter, press

and hold both the UP and DOWN simultaneously until the blind jogs.

Initiate Programming

For Single Channel Transmitters

For Five Channel Transmitters

Programming Instructions are for use with all RTS transmitters

STEP 1: Press and hold the DOWN button and confirm the blind tilts down.

STEP 2: Press and hold the UP button and confirm the blind tilts up.

-If blind direction is not correct (in reverse), press and the (STOP) on

the transmitter until the blind jogs.

Blind direction is now corrected.

Blind movement should now correspond to the direction on

the transmitter.

hold

button

MUST BE DETERMINED BEFORE SETTING BLIND LIMITS

Connect Power to Motor

PROGRAMMING MODE

Check the Direction of Operation

to current blind being programmed. All other blinds should be disconnected from

their respective power while programming is in progress. While programming,

blind should not be inactive for longer than 2 minutes or motor will exit

programming mode.

FACTORY MODE

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 92 93

Sin comentarios

Universal Remote Control Thermo Control Manual de instrucciones Pagina 40