Universal Remote Control TOTAL CONTROL FX-1 Manual de usuario descargar pdf (Pagina 16)

Press the component button you want to turn on and then the

Power ON button; repeat for all other components in the order

you want them to turn on. The LED light will blink once for each

time you press the Power ON button.

Once you’ve entered all the Power On commands, press

the Channel Up button to save your MacroPower commands.

The component button LED light will blink three times to

confirm that the programming has been successfully saved.

SUGGESTION: Most of the components have the same

signal to turn the power On and Off. You may want to

program MacroPower only in the On button and save the

System Off button to turn components On or Off individually.

Note: If you want to program MacroPower for the power

OFF button, follow the same steps used for Power ON

programming.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

Sin comentarios

Universal Remote Control TOTAL CONTROL FX-1 Manual de usuario Pagina 16