Universal Remote Control URC-4041 Manual de usuario descargar pdf (Pagina 16)

URC PLUS User’s Guide



Auto Search Procedures

If your device does not respond to the remote control after trying all devices codes listed for you brand, or if

your brand is not listed at all, try searching for your device code as follows:

1. Turn on your TV or your A/V device.

2. On the remote control, press a device mode key once (i.e., TV or AUX).

NOTE: Use the AUX mode key to program control of VCR, DVD player, cable box, satellite set-top-box

and audio device.

3. Press and hold the “Setup” key until the selected device mode key blinks twice, then release “Setup”.

The device mode key will light up.

4. Press the “POWER” key once.

5. Aim the remote control at the TV. Press either the “CHANNEL UP” key or “CHANNEL DOWN” key to

do device auto-scan:

a. Press the “CHANNEL UP” key to start searching upward at an approx. 5 seconds interval for each

device code. The TV/AUX mode key will be on and blink every 5 seconds while in the device scan

mode.

NOTE: In this search mode, the remote control will send IR codes from the library starting from the

lowest code set number to the end of code set for that device; OR

b. Press the “CHANNEL DOWN” key to start searching downward at an approx. 5 seconds interval

for each code set. The TV mode key will be on and blink every 5 seconds while in the device scan

mode.

NOTE: In this search mode, the remote control will send IR codes from the highest code set number to

the beginning of code set of that device.

6. If the TV turns off, a working code has been found. Press OK once to lock in the code. The selected

mode key will blink twice

7. If all code sets of that device is exhausted in the search and the OK is not pressed, the selected device

key will fast blink 7 times and the search mode will be terminated.

NOTE: Auto-Search does not scan device codes from 4056 to 4071. For decode codes from 4056 to 4071,

you have to enter the device code manually.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Universal Remote Control URC-4041 Manual de usuario Pagina 16