Universal Remote Control URC-4041 Guía de usuario descargar pdf (Pagina 10)

URC 4 User’s Guide



v2.5 for URC 4

Chapter

3.1 Controlling STB using IR URC

Unlike RF, you do not need to do remote registration in order to use URC 4 to control Janus/Amulet through

IR. The remote comes with Janus/Amulet is IR URC 4. However, you have to program the RF URC 4

comes with Entone Second Stream Kit to use IR mode.

To set the RF URC 4 to use IR to control Janus/Amulet:

1. On the URC 4, press and hold the “STB” button for approx. 5 seconds. The “STB” button backlight will

illuminate. Now the URC 4 is in registration mode.

2. On the URC 4, press “STB” once again. Both the “STB” and “AUX” button backlight will illuminate.

3. Press “0” to set RF URC 4 to IR mode only. The RF URC 4 will not send any RF signal.

The “STB” button backlight on the URC 4 will blink twice to indicate that the setting was successful.

Pressing a key other than “0”, “1”, “2”, “3” or a button is not pressed within 30 seconds, the “STB”

backlight will blink rapidly for 7 times to indicate an error and then extinguish, and the URC 4

registration process will be terminated.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Sin comentarios

Universal Remote Control URC-4041 Guía de usuario Pagina 10