Universal Remote Control MC-73CB Guía de usuario descargar pdf (Pagina 165)

MC-8 Troubleshooting and Maintenance

6-3

The MC-8 is powered on, but there is no video.

1. Examine the video cables – particularly the S-Video cables –

to ensure a good connection to the associated component.

2. Check the INPUT SETUP menu VIDEO IN and COMPONENT IN

(page 3-11) parameters to ensure the appropriate video

connector is assigned to the selected input.

RF interference is present in the audio or video.

1. Make sure the MC-8 is not positioned near unshielded TV or FM

antennas, cable TV decoders and other RF-emitting devices.

2. Replace unshielded cables with shielded cables wherever possible.

The MC-8 is exhibiting erratic behavior.

1. Set the rear-panel power switch to the c (“off”) position. Wait

10 seconds. Then set the rear-panel power switch to the |

(“on”) position.

2. Use the MC-8 configuration tool to download the current MC-8

configuration to a personal computer (PC) or document all user-

defined settings on the installation worksheet that begins on

page A-20. Then, follow the instructions on the next page to

restore factory-default settings.

If all else fails...

1. Document all user-defined settings on the installation

worksheet that begins on page A-20. Then, follow the instruc-

tions on page 6-4 to restore factory-default settings.

2. Contact an authorized Lexicon dealer.

3. Contact Lexicon customer service at 781-280-0300 or

www.lexicon.com.

Note:

Visit the knowledgebase at http://www.lexicon.com/kbase for

answers to frequently asked questions and additional trouble-

shooting information.

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 193 194

Sin comentarios

Universal Remote Control MC-73CB Guía de usuario Pagina 165