Universal Remote Control MRX-10 Manual de instalación descargar pdf (Pagina 21)

Page 18

IR Over Narrow Band via Optional RFX-250

Note: RF remotes via RFX-250 can only control IR components.

RS232, Relay and Sensor control are not available to RF remotes.

1. Power on all AV components, lower all dimmers to 50% and

power on anything that may create RF Interference (particularly

devices with high speed microprocessors or hard drives).

2. Check that the address wheel on the back of the MRX-1 is set to

ID#0 (the interference “sniffing” position). If it is not, use the

included small flat blade screwdriver to set the RF ID# to 0.

3. Connect the MRX-1 to its DC wall adapter and plug the wall

adapter into a live AC outlet. Place the MRX-1 in a convenient

central location in the equipment rack. Unlike an MRF-250, the

MRX-1 can be placed next to components with hard drives or

high speed microprocessors. There is no RF circuitry inside the

MRX-1 itself.

4. Connect the RFX-250 to the MRX-1’s RF INPUT jack as shown.

MRX-1 BASE STATION

When connecting a single RFX-250 to the MRX-1 utilize the cable with 3.5

mm plugs on both ends. When you need a longer wire or are connecting

up to three RFX-250s, use a cable with tinned ends or splice it. Cable can

be extended as much as 200’, then connected to the spliced end of a

3.5mm cable.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

Sin comentarios

Universal Remote Control MRX-10 Manual de instalación Pagina 21