Universal Remote Control MRX-10 Manual de instalación descargar pdf (Pagina 7)

Page 4

IR Outputs: Connect emitters for IR control of connected devices.

RFTX Port: Dual port #6 for the RFTX-1 connecting cable or includ-

ed sleeved IR emitter.

RF IN: Connects to a optional single RFX-250 (refer to manual)

RF Out: Used for daisy chaining MRX-1s for RF Operation (Refer to

RFX-250 manual)

RF ID: 15 unique RF ID's provide RF control and routing to multiple

MRX-1’s in the same home. (RF ID #0, the interference "sniffing" posi-

tion, is used to detect RF interference in the area.)

Network Installation

The MRX-1 is a network base station that allows full control of your

components. Once installed to the network, and a button is pressed

on the remote, a command is transferred over the customer’s net-

work to the MRX-1 which sends IR, RS232 or Relay commands to

the devices you specify. Note that the MRX-1 can only be utilized

by URC Network Controls.

1. Connect the Ethernet cable (RJ45) to the rear of the MRX-1 and

into the network router.

2. Connect your laptop into the same network as the MRX-1.

3. Plug flashers into any of the six flasher ports on the rear of the

MRX-1. If you utilize IR output #6, you must

use the pink

sleeved emitter. IR Output #6 is a dual purpose port, it can be

used for IR control or to connect the RFTX-1 for URC Lighting.

MRX-1 BASE STATION

1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

Sin comentarios

Universal Remote Control MRX-10 Manual de instalación Pagina 7