Universal Remote Control URC-A6 El manual del propietario descargar pdf (Pagina 29)

Page | 28

ErasingaSingleLearned

CommandfromOneComponent

STEP1: Press the component button where

the learned command is stored and the

[ENTER] button at the same time for two

seconds until the component light turns on.

STEP2: Press and hold the button you want

to erase for two seconds. The component

light will blink twice to confirm the erasure.

Note: If you do not press a button within 30

seconds, the component light will turn off.

The remote will exit the programming mode,

and you will have to start over with step

one.

STEP3:Repeat Step 2 to erase any other

buttons in the selected component mode.

STEP4:To exit Erase mode, press and hold

both the component button and the [ENTER]

button at the same time until the component

light blinks three times.

Replace

with

high

quality

image

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 46 47

Sin comentarios

Universal Remote Control URC-A6 El manual del propietario Pagina 29