Universal Remote Control R7 - SPECS SHEET Manual de usuario descargar pdf (Pagina 16)

ADP5586 Data Sheet

Rev. 0 | Page 16 of 44

PULSE GENERATORS

The ADP5586 contains two pulse generators that are suitable for

driving indicator LED drive signals, as well as watchdog timers

and other extended time pulsed applications. The ADP5586 allows

for eight bits of definition for both the on time and period of the

generated pulse. To allow for extended timings, the user can choose

between a 1 ms clock and a 125 ms clock to increment these timers.

The PULSE_GEN_1_PERIOD and PULSE_GEN_2_PERIOD

registers (Register 0x30 and Register 0x33, respectively) define

the periods of the two pulse generators. Choosing a clock period

of 125 ms in the PULSE_GEN_CONFIG register (Register 0x35,

Bit 1 and Bit 5) allows for the setting of pulse generator periods

of up to 31.875 sec. Setting the PULSE_GEN_x_ON_CLK bit to

a step size of 125 ms and the PULSE_GEN_x_PRD_CLK bit to

a step size of 1 ms is not a supported configuration.

To support active low applications, a signal inversion can be

programmed in the PULSE_GEN_CONFIG register, using Bit 7

and Bit 3 (PULSE_GEN_x_INV). Delays can be introduced to

create synchronized offsets between the channels. If both channels

are enabled at the same time (that is, enabled from the same I

write), the difference in delays is the offset between the channels.

If a single channel is active and delays are to be synchronized,

the user must first disable both pulse generators before enabling

both pulse generators with the same I

C write command. The

delay counter uses the same clock selection as the period counter.

See Table 56 through Table 61 for more details. To enable pulse

generator output on C1 and/or C0, the GPIO_8_OUT_EN bit

and/or the GPIO_7_OUT_EN bit (Register 0x28, Bits[1:0])

must be enabled.

11148-022

PULSE_GEN_x

PULSE_GEN_x_ON_TIME[7:0]

125ms CLOCK

1ms CLOCK

PULSE_GEN_x_ON_CLK

PULSE_GEN_x_PRD_CLK

PULSE_GEN_x_PERIOD[7:0]

PULSE_GEN_x_DELAY[7:0]

PULSE

GENERATOR

PULSE_GEN_x_INV

ON TIME COUNTER x

PERIOD COUNTER x

DELAY COUNTER x

PULSE_GEN_x_EN

Figure 22. Pulse Generator Block Diagram

11148-023

PERIOD 1

PERIOD 2

PULSE_GEN_1

ON TIME 1

PULSE_GEN_2

ON TIME 2

SDA/SCL

DELAY 1

DELAY 2

Figure 23. Example Pulse Generator Timing

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Comentarios a estos manuales

Sin comentarios

Universal Remote Control R7 - SPECS SHEET Manual de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Universal Remote Control R7 - SPECS SHEET