Universal Remote Control URC-WR7 Especificaciones descargar pdf (Pagina 27)

Page | 26

Channel Control Punch Through

This punch through lets you set up the WR7

remote so that either the Cable or TV Channel

Controls (CHANNEL UP, DOWN, LAST,

CHANNEL NUMBERS 0-9, +10 and ENTER)

will also operate in other component modes on

the remote control.

STEP 1:

Press and hold the component

button you want to add channel control to, such

as [DVD] or [VCR], and the SELECT [SEL] button

at the same time for two seconds until the

Component light turns on. Release the buttons.

STEP 2: Press the CHANNEL UP [CH

]

button. The component LED light will blink once.

Note: If you do not press a button within 30

seconds, the component light will turn off.

The remote will exit the set up mode, and you

will have to start over with step one.

STEP 3: Press either the [TV] or [CABLE/SAT]

button that you want to use as the source of

channel control. The component light will

blink three times to confirm it is saved.

COMPONENT

BUTTONS

SELECT

BUTTONS

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 51 52

Sin comentarios

Universal Remote Control URC-WR7 Especificaciones Pagina 27