Universal Remote Control URC-WR7 Especificaciones descargar pdf (Pagina 31)

Page | 30

Erasing a Single Learned

Command from One Component

STEP 1: Press the component button where the

learned command is stored and the [ENTER]

button at the same time for two seconds until

the component LED light turns on.

STEP 2: Press and hold the button you want

to erase for two seconds. The component

light will blink twice to confirm the erasure.

Note: If you do not press a button within 30

seconds, the component light will turn off.

The remote will exit the set up mode, and

you will have to start over with step one.

STEP 3: Repeat Step 2 to erase any other

buttons in the selected component mode.

STEP 4: To exit Erase mode, press and hold

both the component button and the [ENTER]

button at the same time until the component

light blinks three times.

COMPONENT

BUTTONS

ENTER

BUTTON

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Comentarios a estos manuales

Sin comentarios