Universal Remote Control MX-5000 Guía de usuario descargar pdf (Pagina 53)

Type in Section Title

3 Click on the LEARN icon in the Learn IR toolbar to start the learning process.

4 The “Learning” window opens, The MX-5000 must be connected to the PC. When you see the

“Learn Ready” message, press and hold the corresponding button on the original remote control

while pointing it at the IR Window on the back of the MX-5000. After the IR code is captured, either

“Learn OK” or “ Bad,Try Again” is displayed in the status window.

5 Test the Code. After the code is successfully learned, the window will usually say “Learn OK”, con-

firming that the code was learned “correctly.” Actually, the “OK” means that the code might be

good.... You need to test it. Click on the test button in the Learn IR toolbar to test the code.

6 If the code doesn’t operate the component you can try the Toggle-Bit learning method. This is partic-

ularly useful for components using the Philips RC5 “toggle-bit” protocol. Many high end audio

companies use these codes. Just click on the “2-Learn” icon and you will be prompted to learn every

code twice.

IR Learning

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 90 91

Sin comentarios

Universal Remote Control MX-5000 Guía de usuario Pagina 53